SOURce:DIGital:MEMory:STOP

34980A

SOURce:DIGital:MEMory:STOP

Syntax

SOURce:DIGital:MEMory:STOP (@<ch_list>)

Description

This command stops a buffered (memory) output operation in progress on the 34950A Digital I/O Module. To resume a stopped buffered write, send the SOURce:DIGital:MEMory:STARt command. The width of the first channel in each bank (i.e., channels 101 and 201) controls the width of the memory operations (64K x 8 Bits, 64K x 16 Bits, or 32K x 32 Bits). The first channel on the specified bank must be configured as an output prior to starting a buffered write (see SOURce:DIGital:DATA[:<width>] command) and a trace must be downloaded to memory and assigned to the specified bank (see SOURce:DIGital:MEMory:TRACe command).

Used With:

  • 34950A Digital I/O Module

Parameters

Name

Type

Range of Values

Default Value

<ch_list>

Numeric

The first channel on a bank in the form (@sccc).
Select from s101 or s201.

This is a required parameter

Remarks

  • Depending on the width specified (see SOURce:DIGital:DATA[:<width>] command), the channel numbering is modified as shown below. For example, if you specify the width as a 16-bit WORD, channels 101 and 102 are combined and addressed collectively as channel 101.  

 

Bank 2

Bank 1

BYTE (8 Bits):

Ch 204

Ch 203

Ch 202

Ch 201

Ch 104

Ch 103

Ch 102

Ch 101

WORD (16 Bits):

Ch 203

Ch 201

Ch 103

Ch 101

LWORd (32 Bits):

Ch 201

Ch 101

  • This command overrides the hardware INTR (interrupt) line (see SOURce:DIGital:INTerrupt[:ENABle] command); therefore, you can use the SOURce:DIGital:MEMory:STARt command to start the buffered write even if the bank is configured to start on an interrupt.

Example

The following program segment configures a buffered write on channel 101 on the module in slot 3 and then stops the write.

SOUR:DIG:DATA:WORD #HFFFF,(@3101)  !Set initial output pattern
SOUR:DIG:MEM:NCYC 3,(@3101)  !Output complete trace 3 times
TRAC:DIG:FUNC (@3101),WONES,PATTERN_1,32  !Download "walking ones" pattern
SOUR:DIG:MEM:TRAC PATTERN_1,(@3101)  !Assign trace to channel 101
SOUR:DIG:MEM:ENAB ON,(@3101)  !Enable memory on channel 101
SOUR:DIG:MEM:START (@3101)  !Trigger memory output
SOUR:DIG:MEM:STOP (@3101)
 !Stop memory output

See Also

SOURce:DIGital:DATA[:<width>]

SOURce:DIGital:INTerrupt[:ENABle]

SOURce:DIGital:MEMory:ABORt

SOURce:DIGital:MEMory:NCYCles

SOURce:DIGital:MEMory:STEP

SOURce:DIGital:MEMory:STARt

SOURce:DIGital:MEMory:TRACe

TRACe[:DATA]:DIGital:FUNCtion