CALibration Subsystem Introduction

34980A

CALibration Subsystem Introduction

The CALibration commands are used to calibrate the Agilent 34980A. Please note that the use of these commands requires a detailed knowledge of the appropriate calibration procedures, which are described in the Agilent 34980A Service Guide. Please refer to that guide before attempting to calibrate the instrument as improper use of the CALibration commands can adversely affect the accuracy and reliability of the instrument.

Command Summary
 

Hold the mouse cursor over a command to view the full syntax statement.

 

CALibration?

CALibration:ABORt

, ] (@)" href="CALibration_BEGin.htm">CALibration:BEGin[:VOLTage]

CALibration:COUNt?

CALibration:LFRequency

CALibration:LFRequency?

CALibration:MODule?

" href="CALibration_POINt_.htm">CALibration:POINt?

" href="CALibration_SECure_CODE.htm">CALibration:SECure:CODE

" href="CALibration_SECure_STATe.htm">CALibration:SECure:STATe

CALibration:SECure:STATe?

" [,{1-8|SLOT1-SLOT8|MAINframe|DMM}]" href="CALibration_STRing.htm">CALibration:STRing

CALibration:STRing?

" href="CALibration_VALue.htm">CALibration:VALue

CALibration:VALue?