OUTPut:ALARm<n>:CLEar

34980A

OUTPut:ALARm<n>:CLEar

Syntax

OUTPut:ALARm<n>:CLEar

OUTPut:ALARm:CLEar:ALL

Description

This command clears the specified alarm output line. Send the OUTPut:ALARm:CLEar:ALL command to clear all four alarm output lines.

Used With:

  • 34921A through 34925A Multiplexer Modules

  • 34950A Digital I/O Module (digital input and counter channels only)

  • 34952A Multifunction Module (digital input and totalizer channels only)

Parameters

Name

Type

Range of Values

Default Value

<n>

Discrete

{1|2|3|4}

This is a required parameter

Remarks

  • You can manually clear the output lines at any time (even during a scan) and the alarm data in memory is not cleared (however, data is cleared when you initiate a new scan). The alarm outputs are also cleared when you initiate a new scan.

  • A Factory Reset (*RST command) clears all four alarm outputs but does not clear the alarm queue in either configuration.

Examples

The following command clears alarm output line 2.

OUTP:ALAR2:CLE

The following command clears all four alarm output lines.

OUTP:ALAR:CLE:ALL

See Also

OUTPut:ALARm:MODE

OUTPut:ALARm:SLOPe

OUTPut:ALARm<n>:SOURce