CONFigure:COUNter:PERiod

34980A

CONFigure:COUNter:PERiod

Syntax

CONFigure:COUNter:PERiod [{<gate_time>|MIN|MAX|DEF},] (@<ch_list>)

Description

This command configures the specified counter channels on the 34950A Digital I/O Module to measure the period of the incoming signal (this is the reciprocal of the frequency). For period measurements, you must send the [SENSe:]COUNter:INITiate command to initiate the measurement. The specified gate time is the measurement aperture during which the signal data is gathered. For repetitive signals, longer gate times will lead to increased resolution for frequency, period, pulse width, and duty cycle measurements.

The CONFigure command sets the counter parameters to their default values as shown below.

Parameter

CONFigure Settings

Slope

POSitive (rising edge)

Input Threshold Voltage

2.5V

Gate Source

INTernal

Gate Polarity

NORMal (active high)

Used With:

  • 34950A Digital I/O Module

Parameters

Name

Type

Range of Values

Default Value

<gate_time>

Numeric

Desired gate time between 100 ns and 10 seconds, with 50 ns resolution.

MIN = 100 ns, MAX = 100 seconds

1 ms

<ch_list>

Numeric

One or more counter channels in the form (@sccc).
Select from s301 or s302.

This is a required parameter

Remarks

  • The specified counter channels must detect at least two edges for a valid period measurement. 

Example

The following command configures counter channels 301 and 302 on the module in slot 3 to measure period. The gate time is set to 1 ms.

CONF:COUN:PER 1E-3,(@3301,3302)
COUN:INIT (@3301,3302)
COUN:PER? (@3301,3302)

Typical Response:  +2.89400000E-06,+4.83700000E-06

See Also

CONFigure:COUNter:FREQuency

CONFigure?

MEASure:COUNter:PERiod?

[SENSe:]COUNter:ABORt

[SENSe:]COUNter:DATA?

[SENSe:]COUNter:INITiate

[SENSe:]COUNter:PERiod[:DATA]?