Default Output Settings

WinEDR

Recording Experimental Signals > Creating Stimulus Protocols > Default Output Settings

The default output settings panel sets the default analog and digital output holding levels when a stimulus protocol is NOT in progress.

 

Select
 

Setup
Default Output Settings
 

To open the Default Output Settings control panel

 

 

Analog Output Holding Levels:  Sets the default holding level for the analog outputs. (Note. When an amplifier is defined,the default holding level for the command output of that amplifier can also be set by changing the holding level in the Pipette Seal Test window.)
 

Digital Outputs:  Selecting the appropriate On/Off switch, sets the default voltage levels (ON=5V, OFF=0V) to be output on the digital output lines.

Click the Apply button to apply the settings to the outputs.