WinEDR V3.8.2
Table of contents
- Introduction
-
Getting Started
- Hardware Requirements
- Installing WinEDR
-
Laboratory Interfaces
- National Instruments Interface Cards
- Axon Instruments Digidata 1200
- Cambridge Electronic Design 1401 Series
- Axon Instruments Digidata 1320
- Molecular Devices Digidata 1440A
- Molecular Devices Digidata 1550/1550A/1550B
- Instrutech ITC-16/18
- Biologic VP500
- Tecella Pico/Triton/Triton+
- Heka Patch Clamps & Interfaces
-
Amplifiers
- Patch/Voltage-clamp Amplifiers
- Signal Connections Table
- Configuring Amplifier Support in WinEDR
- Configuring the Axopatch 200 Patch Clamps
- Configuring AMS-2400 patch clamps
- Configuring the NPI ELC-03XS amplifier
- Channel Calibration Table
- CED 1902 Amplifier
- Tecella Patch Clamp Amplifier Control Panel
- Heka EPC9/01 Patch Clamp Control Panel
- Molecular Devices Multiclamp 700A/B
- DCLAMP - Dynamic Clamp
- Recording Experimental Signals
- Displaying Records Stored on File
- Detecting & Analysing Events
-
Analysing Single-channel Currents
- Single-channel Current Analysis
- Current Amplitudes
- Detecting Channel Transitions
- Channel Dwell Time Analysis
- Stability Plots
- Noise Analysis
- Data Files
- Simulations
- COM Automation Interface
- References