Wiping Relay - Pulse Output

FluidSIM 4 Hydraulics

Previous Next

Wiping Relay - Pulse Output

         

An input signal generates a signal of specified length at the output.

The output status is switched to “Hi” after the input Trg is set to “Hi”. The configured time is started at the same time and the output remains set. After expiration of the configured time, the output is reset to the status “Lo” (pulse output). If the input status changes from “Hi” to “Lo” before the specified time has expired, also the output follows immediately with a with a “Hi” to “Lo” transition.

Adjustable parameters

                    Delay time:         0 ... 100 s            (3)

Related Topic

Edge-triggered Wiping Relay


Previous Next