Simulation to a State Change

FluidSIM 4 Hydraulics

Previous Next

Simulation to a State Change

By clicking on  or under Execute- Simulate until State Change the simulation begins and runs up until a certain point where a state change happens; the simulation then pauses (). The following situations describe the point at which the simulation pauses:

 

1.       a cylinder's piston moves at a stop

2.       a valve switches or is operated

3.       a relay switches

4.       a switch is operated

It is possible to switch from a running simulation into this state change mode.

Related Topics

Reset and Restart of the Simulation

Single Step Mode


Previous Next