System Errors
Simulation aborted. The
circuit is too large.
The size of circuit diagrams that can be simulated is bound. You must reduce the number of components.
Internal capacity of
FluidSIM exceeded.
The previous action exceeded the capacity of the internal memory. The action cannot be completed.
No more windows
available.
Microsoft Windows © cannot provide any more windows most likely because the system resources have been exhausted.
Memory capacity
exceeded. Quit other running
applications.
There is not enough memory readily available to complete the parameter calculations. To make more memory available, other circuit diagrams should be closed, along with any other Microsoft Windows © programs that are running. Then attempt to run the simulation again. When there is no other possibility to free up memory, the virtual memory can be increased. Microsoft Windows © then utilizes a section of the hard drive to increase the memory. However, as a result the execution speed of the program decreases greatly. It would be wiser to extend the main memory by increasing the computer's RAM.
This version is not
registered. Please repeat the
installation procedure.
You have tried to start an unlicensed version of FluidSIM. Most likely you have changed your system configuration, or important system files have become corrupt. Attempt to reinstall FluidSIM into the same directory. If there is a problem with the re-installation, you will receive a message on the screen pertaining to the problem. Notify Festo Didactic GmbH & Co. KG of the error or the problem.
Out of memory.
Please save changed
circuits and quit FluidSIM.
While completing an operation (for example loading a circuit diagram, displaying a component photo, rebuilding the desktop) an error in the memory occurred. FluidSIM could not cancel the operation in a proper manner. You are recommended to quit FluidSIM because the program's stability cannot be assured. However, it is still possible to save changes to circuit diagrams before quitting FluidSIM.
Fatal error.
Please save changed
circuits and quit FluidSIM.
A program error has occurred. Please save changes to any open circuit diagrams, quit FluidSIM and Microsoft Windows ©, and restart.
The circuit filename.ct has
not been saved when the last FluidSIM session was terminated
improperly. Shall this file be recovered?
FluidSIM has been terminated in an unexpected manner. However, a backup file was written from which an actual version of the unsaved circuit can be constructed. If the question is answered with “Yes” a window with the recovered circuit is opened; however, the original circuit remains unchanged. You then can decide if to whether the recovered circuit shall be saved under the original name.