Dynamic Generation:Idle State

Short Name: IdleState

Specifies a dynamic generation channel state while the device is idle. The following conditions cause the Idle state to become active:

• The generation session completes normally.
• The generation session pauses from an active Pause trigger.
• The generation session terminates because of an underflow error.
• Channels explicitly disabled with the niHSDIO Tristate Channels VI remain disabled, but the channel data value changes internally. Re-enabling a channel with the niHSDIO Tristate Channels VI while the device is idle causes the channel to go into an Idle state.

This property is valid only for generation sessions.

Tristate (24)	Sets the channel to a high-impedance state. Note  NI 656x devices do not support the tristate Idle state.
Logic high (1)	Sets the channel to a logic-high (high level) state.
Logic low (0)	Sets the channel to a logic-low (low level) state.
Hold last value (27)	The channel retains its previous value.

Remarks

The following table lists the characteristics of this property.