NI SCXI-1166 32-SPDT Topology

The NI SCXI-1366 terminal block provides connections to the NI SCXI-1166 in the 32-SPDT general-purpose topology. The following figure represents the NI SCXI-1166 in the 32-SPDT topology.

Making a Connection

You can control the channels using the niSwitch Connect Channels VI or the niSwitch_Connect function.

To connect the NO terminal to the COM terminal of that channel, disconnect the NC terminal from the COM of that channel.

For example, to connect NO2 to COM2, use the following code:

niSwitch_Disconnect(vi, "nc2", "com2")

niSwitch_Connect(vi, "no2", "com2")

Note  To connect NO to COM you do not need to disconnect NC from COM after the module has been reset or a call to the niSwitch Disconnect All Channels VI or the niSwitch_DisconnectAll function has been made.

Note  niSwitch_Disconnect(vi, "nc2", "com2") does not activate the relay until niSwitch_Connect(vi, "no2", "com2") is executed.

To connect the NC terminal to the COM terminal of that channel, disconnect the NO terminal from the COM of that channel.

For example, to connect NC2 to COM2, use the following code:

niSwitch_Disconnect(vi, "no2", "com2")

niSwitch_Connect(vi, "nc2", "com2")

When scanning the NI SCXI-1166, a typical scan list entry could be nc2->com2;. This entry routes the signal connected to NC2 to COM2.

Pinout

The following figures identify the pins for the NI SCXI-1166 in the 32-SPDT topology.