Accessing DAQ Devices
To access DAQ devices, expand Devices and Interfaces in the configuration tree. From this location, you can perform the following tasks:
- Add a new device to your system
- Configure a device in your system
- Test a device in your system
- Remove a device from your system
- Add NI-DAQ Remote Device Access
For information on configuring system settings, refer to System Settings.
 |
Note If your device is supported in both Traditional NI-DAQ (Legacy) and NI-DAQmx, your device appears under both Devices and Interfaces»Traditional NI-DAQ (Legacy) Devices and Devices and Interfaces»NI-DAQmx Devices. |
|
Note Refer to the Hardware Installation/Configuration Troubleshooter at ni.com/support/install for setup instructions for remote devices using the LabVIEW Real-Time module. |