Trigger mode
You use this to select the trigger mode. The trigger modes are as follows:
None
Auto
Repeat
Single
ETS
If you select None, the remaining trigger options are shaded.
Note: If you select Repeat or Single when using an oscilloscope not belonging to the ADC-200 or PicoScope 2000 or 3000 series, PicoScope locks the computer until a trigger event occurs. If PicoScope does become stuck, click on the Stop button in the sample bar, then press F9 (16-bit applications) or F10 (32-bit applications) to cancel the trigger.
You use this to select the trigger mode. The trigger modes are as follows:
None
| No trigger event, so it collects and displays data continuously
|
Auto
| Starts collecting when a trigger event occurs or after the auto-trigger time, whichever is sooner
|
Repeat
| Starts collecting only when a trigger event occurs. After displaying the data it waits for the next trigger event
|
Single
| Starts collecting only when a trigger event occurs and stops after displaying the data
|
ETS
| This enables ETS (not available with all products)
|
If you select None, the remaining trigger options are shaded.
Note: If you select Repeat or Single when using an oscilloscope not belonging to the ADC-200 or PicoScope 2000 or 3000 series, PicoScope locks the computer until a trigger event occurs. If PicoScope does become stuck, click on the Stop button in the sample bar, then press F9 (16-bit applications) or F10 (32-bit applications) to cancel the trigger.