Electronic Camming LabVIEW Diagram
The following block diagram demonstrates using NI-Motion to perform electronic camming.
 |
Tip Refer to NI-Motion\Documentation\Examples\NI-Motion User Manual\ for the LabVIEW VIs for these examples. |
|
||
| 1 Configure Camming Master | 6 Set Operation Mode | 11 Enable Camming Single Axis |
| 2 Configure Buffer | 7 Load Move Constraint | 12 Clear Buffer |
| 3 Write Buffer | 8 Load Target Position | 13 Motion Error Handler |
| 4 Enable Camming Single Axis | 9 Start Motion | |
| 5 Wait in a Sequence Structure | 10 Wait for Move Complete | |
