Updating Velocity Based on ADC Channel LabVIEW Diagram
The following block diagram demonstrates using NI-Motion to update velocity based on an ADC channel.
 |
Tip Refer to NI-Motion\Documentation\Examples\NI-Motion User Manual\ for the LabVIEW VIs for these examples. |
|
||
| 1 Load Constant to Variable | 6 Read ADC | 11 Start Motion |
| 2 Load Constant to Variable | 7 Multiply Variables | 12 Read Variable |
| 3 Begin Program Storage | 8 Subtract Variables | 13 Jump to Label on Condition |
| 4 Set Operation Mode | 9 Jump to Label on Condition | 14 End Program Storage |
| 5 Insert Program Label | 10 Load Velocity | 15 Motion Error Handler |
