niScope Configure Acquisition

NI-SCOPE LabVIEW

previous page next page

niScope Configure Acquisition

Configures how the digitizer acquires data and fills the waveform record.

instrument handle identifies a particular instrument session.

acquisition type specifies the manner in which the digitizer acquires data and fills the waveform record.

Not all digitizers support all modes; refer to Features Supported by Device for more information.

Default Value: Normal

Defined Values

Normal

Flex Res

DDC

Note Acquisition type DDC applies to the NI 5620/5621 only. To use DDC mode in the NI 5142, leave acquisition type set to Normal and set the DDC Enabled property to True.

error in describes error conditions that occur before this VI runs. The default input of this cluster is no error. If an error already occurred, this VI returns the value of error in in error out. The VI runs normally only if no incoming error exists. Otherwise, the VI passes the error in value to error out. The error in cluster contains the following parameters:

	status is TRUE (X) if an error occurred before this VI or function ran or FALSE (checkmark) to indicate a warning or that no error occurred before this VI or function ran. The default is FALSE.
	code is the error or warning code. The default is 0. If status is TRUE, code is a negative error code. If status is FALSE, code is 0 or a warning code.
	source identifies where an error occurred. The source string includes the name of the VI that produced the error, what inputs are in error, and how to eliminate the error.

instrument handle out has the same value as the instrument handle.

error out contains error information. If error in indicates that an error occurred before this VI or function ran, error out contains the same error information. Otherwise, it describes the error status that this VI or function produces.

	status is TRUE (X) if an error occurred or FALSE (checkmark) to indicate a warning or that no error occurred.
	code is the error or warning code. If status is TRUE, code is a nonzero error code. If status is FALSE, code is 0 or a warning code.
	source identifies where and why an error occurred. The source string includes the name of the VI that produced the error, what inputs are in error, and how to eliminate the error.

previous page start next page