niScope Cal Change Password
Verifies the old password against the one stored in the EEPROM. If the two match, the VI stores the new password in the EEPROM. The password is stored as four characters, but shorter strings are acceptable. For most digitizers, the default password is an empty string. For SMC-based devices, the default password is "NI". If you forget your password, call National Instruments for assistance.
 |
instrument handle identifies a particular instrument session. | ||||||
 |
old password is the password currently stored in the EEPROM. | ||||||
|
new password is the new password to store in the EEPROM. A maximum of 4 characters can be stored. | ||||||
 |
error in describes error conditions that occur before this VI runs. The default input of this cluster is no error. If an error already occurred, this VI returns the value of error in in error out. The VI runs normally only if no incoming error exists. Otherwise, the VI passes the error in value to error out. The error in cluster contains the following parameters:
| ||||||
 |
instrument handle out has the same value as the instrument handle. | ||||||
 |
error out contains error information. If error in indicates that an error occurred before this VI or function ran, error out contains the same error information. Otherwise, it describes the error status that this VI or function produces.
|
