niScope Cal Adjust Internal Reference
For the NI 5911, externally calibrates the internal reference. This VI uses the external reference source instead of the internal reference source to calibrate the vertical range and offset. The internal source voltage is measured, and this value is stored and used for subsequent self-calibrations.
 | Note Use this VI only when following the NI 5911 Calibration Procedure (Start» Programs»National Instruments»NI-SCOPE»Documentation»Calibration). |
 |
instrument handle identifies a particular instrument session. | ||||||
 |
option is not defined. | ||||||
 |
stimulus is the external stimulus applied to the digitizer. Refer to the calibration procedure document for more information. | ||||||
 |
error in describes error conditions that occur before this VI runs. The default input of this cluster is no error. If an error already occurred, this VI returns the value of error in in error out. The VI runs normally only if no incoming error exists. Otherwise, the VI passes the error in value to error out. The error in cluster contains the following parameters:
| ||||||
 |
instrument handle out has the same value as the instrument handle. | ||||||
 |
error out contains error information. If error in indicates that an error occurred before this VI or function ran, error out contains the same error information. Otherwise, it describes the error status that this VI or function produces.
|
