MakeAnnulus Method
Syntax
CWIMAQVision.MakeAnnulus CenterX, CenterY, InnerRadius, OuterRadius, StartAngle, EndAngle
Return Type
The new annulus.
Purpose
Creates a CWIMAQAnnulus object given the properties of the annulus.
Parameters
CenterX As Single
The x-coordinate of the center point.
CenterY As Single
The y-coordinate of the center point.
InnerRadius As Single
The internal radius.
OuterRadius As Single
The external radius.
StartAngle As Single
The start angle, in degrees.
EndAngle As Single
The end angle, in degrees.
Example
Private Sub Run_Click()
'Remove all regions from the viewer
CWIMAQViewer1.Regions.RemoveAll
'Use Make functions to add regions to the viewer
CWIMAQViewer1.Regions.AddAnnulus CWIMAQVision1.MakeAnnulus(50, 50, 5, 40, 45, 315)
CWIMAQViewer1.Regions.AddLine CWIMAQVision1.MakeLine(30, 140, 140, 30)
CWIMAQViewer1.Regions.AddOval CWIMAQVision1.MakeOval(55, 35, 125, 90)
CWIMAQViewer1.Regions.AddPoint CWIMAQVision1.MakePoint(19, 81)
CWIMAQViewer1.Regions.AddRectangle CWIMAQVision1.MakeRectangle(43, 23, 175, 75)
CWIMAQViewer1.Regions.AddRotatedRectangle CWIMAQVision1.MakeRotatedRectangle(130.5, 60.5, 175, 75, 15)
End Sub