Triggering:Start:Digital Edge:Source
Short Name: Start Trigger Digital Edge - Source
Specifies the source terminal for the Start Trigger. This property is used only when the Start Trigger Type property is set to Digital Edge.
You can specify any valid source terminal for this property. Valid sources can be found in Measurement & Automation Explorer under the Device Routes tab.
Source terminals can be specified in two ways. If your device is named Dev1 and your terminal is PFI0, then the terminal can be specified as a fully qualified terminal name, "/Dev1/PFI0". You can also specify the terminal using PFI 0.
The following table provides common relative terminal names:
| PFI0 | PFI 0 on the front panel connector |
| PFI1-PFI3 | PFI <1..3> on the front panel DDC connector |
| PXI_Trig0PXI_Trig7 | PXI_TRIG<0..7> |
| PXI_STAR | PXI_STAR trigger line supported in Slots 3–15 |
Remarks
The following table lists the characteristics of this property.
| Data Type | ViString |
| Permissions | R/W |
| Channel Based | No |
| High-Level VI | None |