niFgen Util Create Waveform Data

From LabView FGEN

previous page next page

niFgen Util Create Waveform Data

Creates a array of doubles filled with the specified waveform.

Waveform specifies waveform information that is used to generate the waveform data.

Waveform Type selects the type of waveform.

Amplitude specifies the amplitude of the waveform that you want the signal generator to produce. This value is the amplitude at the output terminal.

For example, to produce a waveform ranging from -5.00 V to +5.00 V, set Amplitude to 5.00 V. Units: peak voltage

Note This parameter does not affect signal generator behavior when you set Waveform Type to DC.

# of Points specifies the number of points in the waveform.

Waveform Data returns the waveform output.

previous page start next page