PCMCIA-CAN Series 2 Specifications
Power Requirement
+5 VDC (+/– 5%)
| PCMCIA-CAN | 350 mA typical; active |
| 1-port PCMCIA-CAN internal power cable | +55 mA typical |
| PCMCIA-CAN/2 | 350 mA typical; active |
| 2-port PCMCIA-CAN internal power cable | +115 mA typical |
Physical
| Dimensions | 8.56 cm by 5.40 cm by 0.5 cm (3.4 in. by 2.1 in. by 0.2 in.) |
| I/O connector | PCMCIA-CAN cable with 9-pin male D-SUB and pluggable screw terminal for each port |
Operating Environment
| Ambient temperature | 0 to 55 °C |
| Relative humidity | 10 to 90%, noncondensing |
(Tested in accordance with IEC-60068-2-1, IEC-60068-2-2,
EC-60068-2-56.)
Storage Environment
| Ambient temperature | –20 to 70 °C |
| Relative humidity | 5 to 95%, noncondensing |
(Tested in accordance with IEC-60068-2-1, IEC-60068-2-2, EC-60068-2-56.)
Optical Isolation
Isolation up to 500 VDC (withstand, 2s max) channel-to-bus, port-to-port (two-port devices only) in PCMCIA-CAN cables
Synchronization Triggers
| Trigger lines | 4 input/output (TRIG_0–TRIG_3) |
| Clock lines | 1 input (TRIG7_CLK) |
| I/O compatibility | TTL |
| Power-on state | Input (High-Z) |
| Response | Rising Edge Triggers |
| Level | Min | Max |
|---|
| VIL | –0.5 V | 0.8 V |
| VIH | 1.7 V | 5.75 V |
| VOL (IOL = 8 mA) | — | 0.45 V |
| VOH (IOH = 8 mA) | 2.4 V | — |
| Transceiver | Philips TJA1041 |
| Max baud rate | 1 Mbps |
| Min baud rate | 40 kbps |
| CAN_H, CAN_L bus lines | –27 to +40 VDC |
| Power requirement (bus-powered transceiver cables only) | +10 to +30 VDC on V+ connector pin (40 mA typical, 100 mA maximum) (referenced to V–) |
Low-Speed/Fault-Tolerant Transceiver Cable
| Transceiver | Philips TJA1054A |
| Max baud rate | 125 kbps |
| Min baud rate | 5 kbps, 10 kbps min for all error modes |
| CAN_H, CAN_L bus lines | –27 to +40 VDC |
| Power requirements | Internally powered |
Single-Wire Cable
| Transceiver | Philips AU5790 |
| Max baud rate | 33.3 kbps (normal transmission mode), 83.3 kbps (high-speed transmission mode) |
| Min baud rate | 5 kbps, 10 kbps min for all error modes |
| CAN_H bus line | –10 to +18 VDC |
| Power requirement (always required) | +8 to +18 VDC (12 VDC typical) on V+ connector pin (referenced to V–) |