In this exercise, you will use the AutoCAD UNDO command to move the alignment and points back to their original position. However, this will not update the point database, so use the Check Points command to resolve the discrepancy between the position of the points in the drawing and the point database.

1. On the command line, enter UNDO, press ENTER, and then press ENTER again to restore the alignment and points to their original position.

2. On the Points menu, click Check Points Modify Project to display the Modify Project Database Points from Drawing dialog box.

3. In the Scan Drawing for section, verify that COGO Point Objects is selected.

4. In the Modify Project Database section, verify that the Change points in project database check box is selected, and then click OK.

Point update information is displayed on the command line.

This concludes the point editing lesson. In the next lesson, you'll learn about point groups.