 |
A typical programming session - configuring STVP
-
In the Configure menu, click Configure ST Visual Programmer (or press the
button). The Configuration dialog box opens. - From the Hardware list, select the hardware you are using.
- From the Port list, select the parallel port on the host PC to which the EPB or DVP is connected. Only the ports that are compatible with the selected hardware are listed.
- From the Programming mode list, select the programming mode you want to use.
- From the Device list, select the ST microcontroller you want to program.
- Click OK to save your changes and close the dialog box.
TIP: You can also select a ST microcontroller type from the drop-down list in the toolbar.