Update Inspection UI Controls

previous page next page

The following controls are located on the property page for the step.

Control Name	Description
Step Name	Name to give the step.
Run the VI After Updating Indicators	When enabled, the selected custom Inspection Interface VI runs when the Update Inspection Interface UI step executes. The Run the VI After Updating Indicators control is only available if the selected custom Inspection Interface VI contains code on the block diagram.
Inspection Interface Indicators	Displays information about the indicators on the Inspection Interface. The following information is shown for each indicator: Label—Name of the indicator. Value—Displays the value that is used to update the indicator.
Operation	Specifies how the currently selected indicator is updated. The following options are available: Do not Change Current Value—Does not change the indicator value when the step executes. Set to Constant—Sets the indicator value to the specified constant value. Set to Measurement—Sets the indicator value to the value of the selected measurement or variable.
Configure Inspection Interface	Launches the Configure Inspection Interface dialog box, which is used to select the Inspection Interface to use for the inspection.
Show Inspection Interface	Displays the currently selected Inspection Interface.

previous page start next page