 | TCP I/O FAQs |
Q: Why is my device not responding to the TCP commands?
Complete the following steps to ensure that your device is configured correctly:
- Verify that your device is connected to the network.
- If your device is a master device (initiates communication), verify that the device is defined as a master TCP/IP device in the Communication Device Manager and that the TCP server is running.
- If your device is a slave device (receives communication), verify that the device is defined as a slave TCP/IP device in the Communication Device Manager and that the IP Address and TCP Port are correct.
Q: Why are commands not executed when I click the step in the State Configuration window?
In Configuration mode, commands are executed only when you click one of the following buttons:
Run Inspection Once
Run Inspection in Loop
Run Inspection until Failure
Vision Builder AI does not execute the step when you click on the step to avoid potential timeouts associated with the step.