Use Snapshot

FieldPoint Optomux Programming

previous page next page

Use Snapshot

[cmdchars] = !X

Description

The Use Snapshot command enables or disables Snapshot settings for the bank.

Syntax

!X[flag]

[flag]One ASCII-hex character indicates whether the command enables or disables the Snapshot settings as follows:

0Disables the Snapshot settings. If the bank is powered up again, all I/O modules will be initialized to factory default settings.
1Enables the Snapshot settings. If the bank is powered up again, all I/O modules will be initialized to the Snapshot settings.

Success Response

A

Error Responses

E_INVALID_CMDUndefined command.
E_BAD_ADDRESSThe addressed module does not support the command.
E_INV_LIMS_GOTSpecified limits invalid for the command.
E_HW_FAILUREAn unrecoverable fault has occurred.

Refer to FieldPoint Responses for other possible error responses, error numbers, and error descriptions.

Example

>00!X1[checksum][cr]

This command enables the Snapshot settings for the bank at address 0x00.

previous page start next page