Store Snapshot
[cmdchars] = !W
Description
The Store Snapshot command saves all current ranges, attributes, output values, and watchdog settings for all channels in the bank to nonvolatile memory. It also saves the hotswap reporting mode and the turnaround delay for the bank. If the Snapshot feature is enabled, the bank will use the saved settings on future powerups.
This command does not save the watchdog timeout value for the bank. To save the timeout value, use the Store Watchdog Delay (!V) command.
This command returns an error if it is sent to a non-network module.
Syntax
!W
Success Response
A
Error Responses
| E_INVALID_CMD | Undefined command. |
| E_BAD_ADDRESS | The addressed module does not support the command. |
| E_INV_LIMS_GOT | Specified limits invalid for the command. |
| E_HW_FAILURE | An unrecoverable fault has occurred. |
Refer to FieldPoint Responses for other possible error responses, error numbers, and error descriptions.
Example
>00!W[checksum][cr]
This command stores the current ranges, attributes, output values, and watchdog settings for all channels in the bank at address 0x00, as well as the hotswap reporting mode and turnaround delay for the bank.