Standard Optomux Commands
National Instruments recommends using the FieldPoint extended commands whenever possible. The cFP-180x supports only the extended commands and the Power Up Clear command.
Standard commands accept [positions] masks that do not address any channels. Extended commands do not accept such [positions] masks.
| Command Name | Command Syntax | Success Response |
|---|---|---|
| Utility Commands | ||
| Power Up Clear | A | A |
| Reset | B | A |
| Configuration Commands | ||
| Configure As Inputs | H[positions] | A |
| Configure As Outputs | I[positions] | A |
| Configure Positions | G[positions] | A |
| Identify Optomux Type | F | A[type] |
| Read Module Configuration | j | A[config] |
| Set Turnaround Delay | C[data] | A |
| Watchdog Commands | ||
| Enhanced Discrete Watchdog | m[positions][wdgTmo] | A |
| Set Analog Watchdog Data | m[positions][data] | A |
| Set Analog Watchdog Delay | D[positions][wdgTmo] | A |
| Discrete Commands | ||
| Activate Outputs | K[positions] | A |
| Deactivate Outputs | L[positions] | A |
| Read ON/OFF Status | M | A[data] |
| Write Outputs | J[positions] | A |
| Analog Commands | ||
| Read Analog Inputs | L[positions] | A[data] |
| Read Analog Outputs | K[positions] | A[data] |
| Update Analog Outputs | S[positions][data] | A |
| Write Analog Outputs | J[positions][data] | A |