STM8S/A Standard Peripherals Firmware Library: ADC2_ContinuousConversion

STM8S/A

previous page next page
STM8S/A Standard Peripherals Firmware Library
Functions | Variables
ADC2_ContinuousConversion

Functions

static void ADC_Config ()
 Configure ADC2 Continuous Conversion with End Of Conversion interrupt enabled .
static void GPIO_Config (void)
 Configure GPIO for LEDs and buttons available on the evaluation board.
void main (void)
 ADC2_ContinuousConversion main entry point.

Variables

uint16_t Conversion_Value = 0

Function Documentation

static void ADC_Config ( ) [static]

Configure ADC2 Continuous Conversion with End Of Conversion interrupt enabled .

Parameters:
None
Return values:
None

Definition at line 68 of file STM8S_StdPeriph_Examples/ADC2/ADC2_ContinuousConversion/main.c.

References ADC2_ALIGN_RIGHT, ADC2_CHANNEL_9, ADC2_CONVERSIONMODE_CONTINUOUS, ADC2_DeInit(), ADC2_EXTTRIG_TIM, ADC2_Init(), ADC2_ITConfig(), ADC2_PRESSEL_FCPU_D2, ADC2_SCHMITTTRIG_CHANNEL9, ADC2_StartConversion(), DISABLE, ENABLE, enableInterrupts, GPIO_Init(), GPIO_MODE_IN_FL_NO_IT, GPIO_PIN_6, and GPIOE.

Referenced by main().

static void GPIO_Config ( void  ) [static]

Configure GPIO for LEDs and buttons available on the evaluation board.

Parameters:
None
Return values:
None

Definition at line 96 of file STM8S_StdPeriph_Examples/ADC2/ADC2_ContinuousConversion/main.c.

References LED1, LED2, LED3, LED4, and STM_EVAL_LEDInit().

Referenced by main().

void main ( void  )

ADC2_ContinuousConversion main entry point.

Parameters:
None
Return values:
None

Definition at line 50 of file STM8S_StdPeriph_Examples/ADC2/ADC2_ContinuousConversion/main.c.

References ADC_Config(), and GPIO_Config().

Variable Documentation

uint16_t Conversion_Value = 0

Definition at line 39 of file STM8S_StdPeriph_Examples/ADC2/ADC2_ContinuousConversion/main.c.

STM8 Standard Peripherals Library: Footer

 

 

 

      For complete documentation on STM8 8-bit Microcontrollers platform visit www.st.com

 

previous page start next page