STM8S_StdPeriph_Examples/AWU/AWU_ActiveHaltMode/main.c File Reference

This file contains the main function for AWU Active Halt Mode example. More...

#include "stm8s.h" #include "stm8s_eval.h"
#include "stm8s_eval_lcd.h"

Go to the source code of this file.

Functions
void	AWU_Config (void)
	Configure the AWU time base to 12s.
static void	CLK_Config (void)
	Configure system clock to run at 16Mhz.
void	Delay (uint16_t nCount)
	Delay.
static void	GPIO_Config (void)
	Configure GPIO for LEDs and buttons available on the evaluation board.
static void	LCD_Config (void)
	Configure the LCD available on the evaluation board.
uint32_t	LSIMeasurment (void)
	Measure the LSI frequency using timer IC1 and update the calibration registers.
void	main (void)
	Example main entry point.
Variables
bool	ButtonPressed = FALSE

---

Detailed Description

This file contains the main function for AWU Active Halt Mode example.

Author:

MCD Application Team

Version:

V2.2.0

Date:

30-September-2014

Attention:

© COPYRIGHT 2014 STMicroelectronics

Licensed under MCD-ST Liberty SW License Agreement V2, (the "License"); You may not use this file except in compliance with the License. You may obtain a copy of the License at:

http://www.st.com/software_license_agreement_liberty_v2

Unless required by applicable law or agreed to in writing, software distributed under the License is distributed on an "AS IS" BASIS, WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. See the License for the specific language governing permissions and limitations under the License.

Definition in file STM8S_StdPeriph_Examples/AWU/AWU_ActiveHaltMode/main.c.