|
STM8S/A Standard Peripherals Firmware Library
|
This file contains the main function for CAN networking example. More...
#include "main.h"
Go to the source code of this file.
Functions | |
| void | CAN_Config (void) |
| Configures the CAN mode and filter. | |
| void | CLK_Config (void) |
| Configure system clock to run at 16Mhz. | |
| void | Delay (uint16_t nCount) |
| Generates a delay time. | |
| void | GPIO_Config (void) |
| Configure GPIO for LEDs and buttons available on the evaluation board. | |
| void | LCD_Config (void) |
| Configure the LCD available on the evaluation board. | |
| void | LCD_Display (uint8_t Ledstatus) |
| Display led status and communication direction on the LCD. | |
| void | LED_Display (uint8_t Ledstatus) |
| Display led status. | |
| void | main (void) |
| Main program. | |
Variables | |
| uint8_t | Key_Pressed_Number = 0x00 |
| __IO uint8_t | Key_status = 0x00 |
Detailed Description
This file contains the main function for CAN networking example.
- Author:
- MCD Application Team
- Version:
- V2.2.0
- Date:
- 30-September-2014
- Attention:
© COPYRIGHT 2014 STMicroelectronics
Licensed under MCD-ST Liberty SW License Agreement V2, (the "License"); You may not use this file except in compliance with the License. You may obtain a copy of the License at:
http://www.st.com/software_license_agreement_liberty_v2
Unless required by applicable law or agreed to in writing, software distributed under the License is distributed on an "AS IS" BASIS, WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. See the License for the specific language governing permissions and limitations under the License.
Definition in file STM8S_StdPeriph_Examples/CAN/CAN_Networking/main.c.