STM8S_StdPeriph_Examples/UART1/UART1_HyperTerminal_Interrupt/main.c File Reference

This file contains the main function for UART1 using interrupts in communication example. More...

#include "stm8s.h" #include "stm8s_eval.h"

Go to the source code of this file.

Functions
static void	CLK_Config (void)
	Configure system clock to run at 16Mhz.
void	Delay (uint32_t nCount)
	Delay.
static void	GPIO_Config (void)
	Configure LEDs available on the evaluation board.
void	main (void)
	Main program.
static void	UART1_Config (void)
	Configure UART1 for the communication with HyperTerminal.

---

Detailed Description

This file contains the main function for UART1 using interrupts in communication example.

Author:

MCD Application Team

Version:

V2.2.0

Date:

30-September-2014

Attention:

© COPYRIGHT 2014 STMicroelectronics

Licensed under MCD-ST Liberty SW License Agreement V2, (the "License"); You may not use this file except in compliance with the License. You may obtain a copy of the License at:

http://www.st.com/software_license_agreement_liberty_v2

Unless required by applicable law or agreed to in writing, software distributed under the License is distributed on an "AS IS" BASIS, WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. See the License for the specific language governing permissions and limitations under the License.

Definition in file STM8S_StdPeriph_Examples/UART1/UART1_HyperTerminal_Interrupt/main.c.