CAN/CAN_Networking/main.h File Reference

This file contains the external declaration of main.c file. More...

#include "stm8s.h" #include "stm8s_eval.h"
#include "stm8s_eval_lcd.h"

Go to the source code of this file.

Defines
#define	Key_NoPressed   0x00
#define	Key_Pressed   0x01
#define	TIME   0x7FFF
Functions
void	CAN_Config (void)
	Configures the CAN mode and filter.
void	CLK_Config (void)
	Configure system clock to run at 16Mhz.
void	Delay (uint16_t nCount)
	Delay.
void	GPIO_Config (void)
	Configure GPIO for LEDs and buttons available on the evaluation board.
void	LCD_Config (void)
	Configure the LCD available on the evaluation board.
void	LCD_Display (u8 Ledstatus)
	Display led status and communication direction on the LCD.
void	LED_Display (u8 Ledstatus)
	Display led status.

---

Detailed Description

This file contains the external declaration of main.c file.

Author:

MCD Application Team

Version:

V2.0.1

Date:

18-November-2011

Attention:

© COPYRIGHT 2014 STMicroelectronics

Licensed under MCD-ST Liberty SW License Agreement V2, (the "License"); You may not use this file except in compliance with the License. You may obtain a copy of the License at:

http://www.st.com/software_license_agreement_liberty_v2

Unless required by applicable law or agreed to in writing, software distributed under the License is distributed on an "AS IS" BASIS, WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. See the License for the specific language governing permissions and limitations under the License.

Definition in file CAN/CAN_Networking/main.h.

---

Define Documentation

#define Key_NoPressed   0x00

Definition at line 41 of file CAN/CAN_Networking/main.h.

Referenced by main().

#define Key_Pressed   0x01

Definition at line 40 of file CAN/CAN_Networking/main.h.

#define TIME   0x7FFF

Definition at line 42 of file CAN/CAN_Networking/main.h.

Referenced by main().