|
STM8S/A Standard Peripherals Firmware Library
|
This file contains the main function for UART1 Synchronous mode example. More...
#include "stm8s.h"
Go to the source code of this file.
Defines | |
| #define | countof(a) (sizeof(a) / sizeof(*(a))) |
| #define | TxBufferSize1 (countof(TxBuffer1) - 1) |
| #define | TxBufferSize2 (countof(TxBuffer2) - 1) |
Enumerations | |
| enum | TestStatus { FAILED = 0, PASSED = !FAILED, FAILED = 0, PASSED = !FAILED, FAILED = 0, PASSED = !FAILED, FAILED = 0, PASSED = !FAILED, FAILED = 0, PASSED = !FAILED, FAILED = 0, PASSED = !FAILED, FAILED = 0, PASSED = !FAILED, FAILED = 0, PASSED = !FAILED, FAILED = 0, PASSED = !FAILED, FAILED = 0, PASSED = !FAILED } |
Functions | |
| TestStatus | Buffercmp (uint8_t *pBuffer1, uint8_t *pBuffer2, uint16_t BufferLength) |
| Compares two buffers. | |
| static void | CLK_Config (void) |
| Configure system clock to run at 16Mhz. | |
| void | Delay (uint16_t nCount) |
| Delay. | |
| void | main (void) |
| Main program. | |
| static void | SPI_Config (void) |
| Configure SPI for the full duplex communication with UART1. | |
| static void | UART1_Config (void) |
| Configure UART1 for the synchronous mode communication. | |
Variables | |
| uint8_t | NbrOfDataToRead = TxBufferSize1 |
| uint8_t | RxBuffer1 [TxBufferSize2] = {0} |
| uint8_t | RxBuffer2 [TxBufferSize1] = {0} |
| __IO uint8_t | RxCounter = 0 |
| __IO TestStatus | TransferStatus1 = FAILED |
| __IO TestStatus | TransferStatus2 = FAILED |
| uint8_t | TxBuffer1 [] = "UART1 Example: UART1 -> SPI using TXE and RXNE Flags" |
| uint8_t | TxBuffer2 [] = "UART1 Example: SPI -> UART1 using TXE and RXNE Flags" |
| __IO uint8_t | TxCounter = 0 |
Detailed Description
This file contains the main function for UART1 Synchronous mode example.
- Author:
- MCD Application Team
- Version:
- V2.2.0
- Date:
- 30-September-2014
- Attention:
© COPYRIGHT 2014 STMicroelectronics
Licensed under MCD-ST Liberty SW License Agreement V2, (the "License"); You may not use this file except in compliance with the License. You may obtain a copy of the License at:
http://www.st.com/software_license_agreement_liberty_v2
Unless required by applicable law or agreed to in writing, software distributed under the License is distributed on an "AS IS" BASIS, WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. See the License for the specific language governing permissions and limitations under the License.
Definition in file STM8S_StdPeriph_Examples/UART1/UART1_Synchronous/main.c.