|
STM8S/A Standard Peripherals Firmware Library
|
This file contains the main function for:use the UART1 in multi-processor mode example. More...
Go to the source code of this file.
Functions | |
| void | Delay (uint32_t nCount) |
| Delay. | |
| static void | GPIO_Config (void) |
| Configure GPIO for Leds and buttons available on the evaluation board. | |
| void | main (void) |
| Main program. | |
| static void | UART_Config (void) |
| UART1 and UART3 Configuration for multi processor communication. | |
Detailed Description
This file contains the main function for:use the UART1 in multi-processor mode example.
- Author:
- MCD Application Team
- Version:
- V2.2.0
- Date:
- 30-September-2014
- Attention:
© COPYRIGHT 2014 STMicroelectronics
Licensed under MCD-ST Liberty SW License Agreement V2, (the "License"); You may not use this file except in compliance with the License. You may obtain a copy of the License at:
http://www.st.com/software_license_agreement_liberty_v2
Unless required by applicable law or agreed to in writing, software distributed under the License is distributed on an "AS IS" BASIS, WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. See the License for the specific language governing permissions and limitations under the License.
Definition in file STM8S_StdPeriph_Examples/UART1/UART1_MultiProcessor/main.c.