Specifying Threads Per Processor on IIS
When using RDS with Internet Information Services (IIS) 4.0 or later, the number of threads created per processor can be controlled by manipulating the registry on the Web server. The number of threads per processor can affect performance in a high traffic situation, or in low traffic situations with large query sizes. The user should experiment for best results.
The method used to determine and change the default value for this setting depends upon the configuration of the IIS 4.0 server.
With MDAC 2.1.2.4202.3 (GA) or later installed on the IIS server, RDS uses the same Component Services (or Microsoft Transaction Services, if you are using Windows NT) thread pool as ASP scripts use. The default value for the number of threads per processor is 10. To change the default, you must add the following key to the server registry:
HKEY_LOCAL_MACHINE\System\CurrentControlSet\Services\InetInfo\Parameters\MaxPoolThreads
where MaxPoolThreads is a REG_DWORD. MaxPoolThreads does not appear in the Registry unless it is specifically added. Valid values range from 5 to a recommended maximum of 20. If the value specified by the registry key is greater than the value of the PoolThreadLimit key (located under the same path), then PoolThreadLimit value is used.
Alternatively, if MDAC 2.1 2.1.1.3711.11 (GA) or earlier is installed on the IIS server, the default value for the number of threads per processor is 6. To change the default, you must add the following key to the registry on the IIS server:
HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Services\W3SVC\Parameters\ADCThreads
where ADCThreads is a REG_DWORD. ADCThreads does not appear in the Registry unless it is specifically added. The range of valid values is 1 to 50. If the value specified by the registry key is greater than 50, then the maximum value is used (50).