Adding SCC Modules

Note  Before you add an SCC module, you must add an SCC connector block.

To add an SCC module, complete the following steps:

1. Expand Devices and Interfaces»NI-DAQmx Devices.

   If you are using a remote RT target, expand Remote Systems, find and expand your target, and expand Devices and Interfaces»NI-DAQmx Devices.

2. Right-click the SCC connector block to which you want to add a module. Select Properties.

   –or–

   Expand the SCC connector block and right-click an empty slot. Select Insert.

3. In the SCC Carrier Configuration window, add a power module to the POWER slot. After adding a power module, select other modules you want to add from the drop-down listbox for the desired slot.
4. Click OK when you are finished.

You can also rename and remove SCC modules.