Adding an SCC Connector Block

NI IMAQ Measurement and Automation Explorer

Adding an SCC Connector Block

To add an SCC connector block, complete the following steps:

  1. Right-click Devices and Interfaces. Select Create New.

    If you are using a remote RT target, expand Remote Systems, find and expand your target, and right-click Devices and Interfaces. Select Create New.

  2. In the Create New window, go to NI-DAQmx Device»NI-DAQmx SCC Connector Block. Select the SCC connector block you want to add.
  3. Click Finish.

You can also add an SCC connector block without using the Create New window. Complete the following steps:

  1. Right-click Devices and Interfaces»NI-DAQmx Devices.

    If you are using a remote RT target, expand Remote Systems, find and expand your target, and right-click Devices and Interfaces»NI-DAQmx Devices.

  2. Select Create New DAQmx Device»NI-DAQmx SCC Connector Block.
  3. Select a connector block from the list of available SCC connector blocks.

In the SCC Connector Block Configuration window, configure your settings.