expression.AddConnector(Type, BeginX, BeginY, EndX, EndY)
expression Required. An expression that returns one of the objects in the Applies To list.
Type Required MsoConnectorType. The type of connector.
| MsoConnectorType can be one of these MsoConnectorType constants. |
| msoConnectorCurve |
| msoConnectorElbow |
| msoConnectorStraight |
| msoConnectorTypeMixed |
BeginX Required Single. The horizontal position, measured in points, of the connector's starting point relative to the left edge of the slide.
BeginY Required Single. The vertical position, measured in points, of the connector's starting point relative to the top edge of the slide.
EndX Required Single. The horizontal position, measured in points, of the connector's ending point relative to the left edge of the slide.
EndY Required Single. The vertical position, measured in points, of the connector's ending point relative to the top edge of the slide.
Remarks
When you attach a connector to a shape, the size and position of the connector are automatically adjusted, if necessary. Therefore, if you're going to attach a connector to other shapes, the position and dimensions you specify when adding the connector are irrelevant.
Example
This example adds two rectangles to myDocument and connects them with a curved connector. Note that when you attach the connector to the rectangles, the size and position of the connector are automatically adjusted; therefore, the position and dimensions you specify when adding the callout are irrelevant (dimensions must be nonzero).
Sub NewConnector()
Dim shpShapes As Shapes
Dim shpFirst As Shape
Dim shpSecond As Shape
Set shpShapes = ActivePresentation.Slides(1).Shapes
Set shpFirst = shpShapes.AddShape(Type:=msoShapeRectangle, _
Left:=100, Top:=50, Width:=200, Height:=100)
Set shpSecond = shpShapes.AddShape(Type:=msoShapeRectangle, _
Left:=300, Top:=300, Width:=200, Height:=100)
With shpShapes.AddConnector(Type:=msoConnectorCurve, BeginX:=0, _
BeginY:=0, EndX:=100, EndY:=100).ConnectorFormat
.BeginConnect ConnectedShape:=shpFirst, ConnectionSite:=1
.EndConnect ConnectedShape:=shpSecond, ConnectionSite:=1
.Parent.RerouteConnections
End With
End Sub