Initial Settings
Contains the list of converted attribute value settings applied at initialization. Use the Remove button to remove settings from the list.
 |
Note The Default Setup data has been replaced by Configurable Initial
Settings. Because the Configurable Initial Settings are selected by the software module developer, and
are recognized by the software module during initialization, Configurable Initial Settings are only
added by the software module when it is installed. Using Configurable Initial Settings is more
restrictive than using the Default Setup. The set of attributes available to your driver sessions in
the
Configurable Initial Settings is restricted to what is published by the driver developer in the
software module entry for that driver. You can edit the value of these attributes for your driver
session but you cannot add additional attributes to this list of Configurable Initial Settings.
If you need attributes that are not available in the Configurable Initial Settings list, National Instruments recommends that you contact the specific driver supplier. |