Configure Network Settings

Complete the following steps to configure the network settings:

1. If the analyzer is capturing, stop capture. Refer to Start and Stop Capture for details.
2. Select Settings»Network Settings... to open the network settings dialog.
3. Select the interface name of your National Instruments interface, which could be:
• Physical interfaces, from CAN0 to CAN63.
• Virtual interfacesi, CAN256 or CAN257.

Refer to What is Virtual Interface? for details.

4. Select the baud rate your DeviceNet network uses. The DeviceNet specification allows either 125000, 250000, or 500000 bps.
5. Click OK.

Note  The analyzer uses the interface name and baud rate assigned in MAX as default network settings.