Configure Filter Settings
You can use the filter to select desired packets to be captured or displayed.
Complete the following steps to configure the filter settings:
- If the analyzer is capturing, stop capture. Refer to Start and Stop Capture for details.
- Select Settings»Filter Settings... to open the filter settings dialog.
- Click Enable or Disable to enable or disable the filter.
- If the filter is enabled, check the corresponding check boxes on each filter page to select your desired packets.
- Click OK.
| Note If the filter is enabled during capture, the analyzer discards all packets that do not match the filter. After capture, you can change filter settings to view more desired packets. However, all original captured packets are still retained in the current document. |