Multi-Device NI-488.2 Calls
From NI-488.2
Multi-Device NI-488.2 Calls
| AllSpoll | Serial poll all instruments |
| DevClear | Clear a single instrument |
| DevClearList | Clear multiple instruments |
| EnableLocal | Enable operations from the front panel of instruments (leave remote programming mode) |
| EnableRemote | Enable remote GPIB programming for instruments |
| FindLstn | Find listening instruments on the GPIB |
| FindRQS | Determine which instrument is requesting service |
| PassControl | Pass control to another instrument with Controller capability |
| PPoll | Perform a parallel poll on the GPIB |
| PPollConfig | Configure an instrument to respond to parallel polls |
| PPollUnconfig | Unconfigure instruments for parallel polls |
| RcvRespMsg | Read data bytes from an instrument that is already addressed to talk |
| ReadStatusByte | Serial poll a single instrument |
| Receive | Read data bytes from an instrument |
| ReceiveSetup | Address an instrument to be a Talker and the interface to be a Listener in preparation for RcvRespMsg |
| ResetSys | Reset and initialize IEEE 488.2-compliant instruments |
| Send | Send data bytes to an instrument |
| SendCmds | Send GPIB command bytes |
| SendDataBytes | Send data bytes to instruments that are already addressed to listen |
| SendIFC | Reset the GPIB by sending interface clear |
| SendList | Send data bytes to multiple GPIB instruments |
| SendLLO | Send the Local Lockout (LLO) message to all instruments |
| SendSetup | Set up instruments to receive data in preparation for SendDataBytes |
| SetRWLS | Place instruments in Remote With Lockout State |
| TestSRQ | Determine the current state of the GPIB Service Request (SRQ) line |
| TestSys | Cause IEEE 488.2-compliant instruments to conduct self tests |
| Trigger | Trigger an instrument |
| TriggerList | Trigger multiple instruments |
| WaitSRQ | Wait until an instrument asserts the GPIB Service Request (SRQ) |