FT2232D Device Options

MProg

FT2232D Device Options
Return to Introduction  Previous page  Next page
The FT2232D device incorporates all of the BM specific features described in the BM/C Device Specific Options section and all of the FT2232C Device Options, but with an additional "CPU FIFO" option made available.

   ft2232d_device_options

·Each channel can be independently configured as FT232BM-style USB UART or a FT245BM-style USB FIFO.  

·Each channel can be individually configured in CPU FIFO mode.  

·Each channel can also be individually configured in Fast Opto-Isolated Serial Interface mode. See the FT2232C device datasheet (available from the Datasheets page of the FTDI website) for more information on these modes.  

·High Current I/O's. Setting this option will enable the high output drive level. The UART/FIFO IO pins will drive out at 12mA instead of their normal 4mA.  

·The driver that is installed and used by each channel can be set by selecting Virtual COM Port or D2XX Direct option (not currently supported).