KL3132, KL3142, KL3152, KL3162, KL3172, KL3182 - LEDs

BECKHOFF KL31x2

previous page next page
 
BECKHOFF KL3132, KL3142, KL3152, KL3162, KL3172, KL3182: Product Overview

LEDs

LED Display
K-Bus Power
(green)		 ON K-Bus power supply (5 V) present
OFF K-Bus power supply (5 V) not present
K-Bus Run
(green)		 ON K-Bus data transfer active
OFF K-Bus data transfer not active
Run 1
(green)		 ON Channel 1 active:
  • process data contain valid analog value
OFF Channel 1 not active:
  • calibration is being carried out, process data do not contain an up-to-date analog value (frozen) or
  • channel is disabled (if LED Error 1 does not shine)
Error 1
(red)		 ON
  • The analog value is above the valid measuring range as specified via register R21 of channel 1. The bit SB1.1 is set in status byte for channel 1.
  • The analog value is below the valid measuring range as specified via register R22 of channel 1. The bit SB1.0 is set in status byte for channel 1.
OFF
  • the analog value of channel 1 is within the valid measuring range (if LED Run 1 shines) or
  • channel 1 is disabled (if LED Run 1 does not shine)
Run 2
(green)		 ON Channel 2 active:
  • process data contain valid analog value
OFF Channel 2 not active:
  • calibration is being carried out, process data do not contain an up-to-date analog value (frozen) or
  • channel is disabled (if LED Error 2 does not shine)
Error 2
(red)		 ON
  • The analog value is above the valid measuring range as specified via register R21 of channel 2. The bit SB2.1 is set in status byte for channel 2.
  • The analog value is below the valid measuring range as specified via register R22 of channel 2. The bit SB2.0 is set in status byte for channel 2.
OFF
  • the analog value of channel 2 is within the valid measuring range (if LED Run 2 shines) or
  • channel 1 is disabled (if LED Run 2 does not shine)
Limiting the measuring range

The terminal indicates any violation of the measuring range to the higher-level controller via the status byte. If the current measured value

  • is greater than specified in register R21, bit 1 of status byte is set.
  • is less than specified in register R22, bit 0 of status byte is set.

In both cases, the ERROR LED of the respective channel will be on. This display can be deactivated with bit R32.8.

previous page start next page