3D View
3D View shows 3D projection of the model, imported objects and fields. It also allows to user modify the geometry of the model. Two main modes are supported.
Rendering mode is used to visualize the model. Selection and motion of the vertices is disabled. To rotate, shift or zoom the model use following commands.
| Command | Action |
| right mouse button down | Opens 3D View property sheet. |
| left mouse button down + mouse move | Rotates the model. |
| SHIFT + left mouse button down + mouse move | Shifts the model. |
| mouse wheel | Zooms the model. |
| CTRL + mouse move | Zooming. |
| key LEFT, RIGHT | Rotates the model about the vertical axis. |
| key UP, DOWN | Zooms the model. |
| key Page Up, Page Down | Shift the model along vertical axis. |
| E | Set the view from E to W. |
| W | Set the view from W to E. |
| N | Set the view from N to S. |
| S | Set the view from S to N. |
| M | Map View. |
Selection mode is used for
interactive
modification
the model in 3D. The table below describes the commands used in modification,
which differs from the rendering mode (previous
table).
| Command | Action |
| CTRL + left mouse button down + mouse move | Zooms the model. |
| CTRL + SHIFT + left mouse button down + mouse move | Rotates the model. |
| left mouse button click on body vertex + mouse move | Moves the body vertex along vertical. See model modification for details. |