Configuration using PICDEM FS USB Board

Smart Card Library

previous page next page
Smart Card Library
Contents | Index | Reference | Home
Previous | Up | Next
Configuration using PICDEM FS USB Board

  1. If using the PICDEM FS USB Demo Board, no hardware related configuration or jumper setting changes should be necessary. The demo board need only be programmed with appropriate firmware.
 

 

  1. Don’t short the jumper at J11 port.
  2. Insert the J2 port of SC (Smart/Sim Card) PICTail card into J3 port of PICDEM FSUSB board as per the pin configuration. Insert the Smart Card in SC PICTail board.

Getting Started - Smart Card Demo > Configuring the Hardware: > Configuration using PICDEM FS USB Board
Microchip Smart Card Library 1.02.8 - [July 18, 2012]
Copyright © 2012 Microchip Technology, Inc.  All rights reserved.
Contents | Index | Reference | Home
previous page start next page