Configuration using PIC18F14K50 + LPC Board

Smart Card Library

Smart Card Library
Configuration using PIC18F14K50 + LPC Board

Ensure that JP1 of SC PICTail card & J12 of LPC board are left open. One side of J4 port pins of the SC PICTail card matches with the J11 port of LPC board. Insert the matching side of J4 port of SC PICTail board into the J11 port of LPC board. Make sure that the Smart Card Connector is facing towards the LPC board. Insert the Smart Card in SC PICTail board. 

Apart from the above guidelines, couple of below steps has to be followed to make the demo work:-

  1. Short Tx & Rx line of the UART (i.e. short pin 1 & pin 6 of J13 port using a wire in the LPC board) and connect it to I/O pin of SC PICTail board.
  2. Connect RB6 (i.e. pin 5 of J13 port in LPC board) to “Card Present” signal pin of SC PICTail board as shown below.
 

 

Microchip Smart Card Library 1.02.8 - [July 18, 2012]
Copyright © 2012 Microchip Technology, Inc.  All rights reserved.