Configuration using PIC18 Explorer Board

Smart Card Library

Smart Card Library
Configuration using PIC18 Explorer Board

  1. Before inserting PIC18F87J50 PIM or PIC18F46J50 PIM in the PIC18 Explorer board, insure that the processor selector switch (S4) is in the “ICE” position as seen in the image below. Failure to so will result in difficulties in getting the PIC18F87J50/PIC18F46J50 PIM to sit properly on the PIC18 Explorer.
 

 

  1. Before inserting PIC18F87J50/PIC18F46J50 PIM into the PIC18 Explorer board, remove all the attached cables from both the boards. Be careful while inserting the PIM into PIC18 board. Insure that no pins are bent or damaged during the process. Also insure that the PIM is not shifted in any direction and that all of the headers are properly aligned.
  2. Insert the J4 port pins of SC (Smart/Sim Card) PICTail Board in the J3 port of PIC18 Explorer board. Make sure that the Smart Card Connector is facing towards the PIC18 Explorer board. Insert the Smart Card in SC PICTail Board.
 

Microchip Smart Card Library 1.02.8 - [July 18, 2012]
Copyright © 2012 Microchip Technology, Inc.  All rights reserved.